In some situations you may need to sanitize the syrup lines for your Pepsi fountain equipment. The video below will show you how to do this:
Or if you prefer not to watch a video, these are the steps:
- Remove product bag from empty syrup box and cut the green connector off of the bag end (not the line end), then clean the connector
- Disconnect product from the line you are sanitizing and screw on the connector you just cleaned
- Submerge the connector and line in a bucket of clean warm water (refill the bucket as needed)
- At the fountain run the flavor until the line runs clear
- Create a sanitizing solution in the bucket (mix half tablespoon of chlorine solution per 2 gallons of water)
- Place syrup line connector in the sanitizing solution and again run the flavor at the fountain refilling sanitizer as needed (approximate pour time is 30 seconds per 20 feet of syrup line length)
- Allow the sanitizer solution to sit in the lines for 10 minutes
- Rinse sanitizer out of the bucket and refill with warm water
- Place syrup line connector in the water and again run the flavor at the fountain refilling as needed (approximate pour time is 30 seconds per 20 feet of syrup line length)
- Use a chlorine test strip and ensure you have cleared the sanitizer from the lines
- Remove the cut-out bag connector from the syrup line and replace your syrup box
- At the dispenser, dispense until the product runs through, plus two additional pitchers of product